Suggestions (предложения)

[somacast]

(05.12.2016 18:01)aldair писал(а):  

(05.12.2016 16:34)dragoncity писал(а):  What is your message SWAT? I received a notification ^^

So..the problem with the SATA..it's the adaptors...and it blocks after detection of hard disk ! (very boring !!)

I tested 8 SAME adaptors sata..and 4 works..and 4 doesn't work !!

The problem is the GROUND..BAD SOLDER !!

I spoke in my video,but it's in french sorry







Sometimes it's more,you must check ALL solder !!

I hope my test can be help you...

It does not work with large wires.

look here; http://www.dc-swat.ru/forum/thread-2522.html

thnx alot aldair for posting the photos of my mod, in fact I would have never succeeded without your tutorials & answers.

i also had many unsuccessful attempts, but the best way is to connect the adapter directly to the board, use a thick wire (really thick) for both ground connections on the ends, and even the wires between the points and the adapter needs to be thicker than usual small dia wires used in modchips etc.

another thing is you need to be really careful with the solder points on the adapter as its usually cheap quality and tends to get destroyed.

also I have not removed the sata socket as you can see from the adapter as I removed the metalic shell under the dc motherboard so it fits without a problem, then you can use male-female ends sata cable and route it to where ever you need

power required by the adapter is just 1 point 5v, the other is 12 v.

i hope this helps