No GD-ROM, Can't read MBR from IDE by LBA

[jacobsson]

(30.04.2016 15:42)polyfusion писал(а):  I got it working, I was looking at some photos of HDD's people were using in their DCs, and could just about make out that they were jumpered. So I put a jumper on the two pins that looked like it needed it, and it works great now.

Also, I see 3 solder points which look like they are in the right location for the DCs lid switch. Had anyone installed a switch, and advantage/disadvantage to doing so?

Many thanks to everyone who made this happen.

Hi! I just dusted off my XCKDIY HDD adapter and I remember last time I tested it that I never got I working (with a known working drive pulled from my soldered G1-ATA SATA mod). It halted on the init-screen for G1-ATA and SD devices.
What pins did you add a jumper between? Thanks a lot for your answer!