G1-ATA Devices

[SWAT]

(01.04.2014 23:58)OzOnE писал(а):  It should work fine with an IDE cable in-between, but it's preferable to use the older 40-wire IDE cable with it.

I have used an 80-wire "UDMA" cable with it as well, and it's best to have the Blue connector at the DC end if you do.
(If you do have problems with getting it working, then try to get hold of a 40-wire IDE cable.)

I found the IDE hard drive (40GB).
I'm Plugged it as slave with 80-wire cable, console boot well (with CF/SATA adapters this was not), but the drive is not detected
Cable and HDD working, I checked on the PC.
For test I tried to do the drive and as master and got the same result as with CF/SATA adapters (DC is not booting).
It turns out that everything seems to be fine, but why it is not detected? Because of the UDMA cable? I do not have a 40-wire cable and I do not know where to find it...