DreamShell v4.0.0 Release

[yo4yo4]

(02.03.2024 11:34)svk77 писал(а):  

(22.02.2024 11:56)yo4yo4 писал(а):  Country Europe Broadcast PAL Language French
AND
USA NTSC English
Japan NTSC Japan

Use DMA transfer ON
Emulate async true
Emulate CDDA ON
IRQ hooking ON
Binary OS Auto
BOOT Direct

Loader memory 0x8c001100

Sega Rally 2 v1.000 (1999)(Sega)(PAL)[!]
Sega Rally 2 v1.001 (1999)(Sega)(PAL)[!]

Loader memory 0x8c000100

Sega Rally 2 v1.003 (1999)(Sega)(US)[!]
[GDI] Sega Rally 2 [truncated]

IRQ hooking OFF

Sega Rally 2 v1.04 (1999)(Sega)(JP)(en)[!][HJ120D, HJ121A, HJ121E, HJ122C]
Sega Rally 2 v1.04 (1999)(Sega)(JP)[!][10M3, 10MM1]
Sega Rally 2 v1.04 (1999)(Sega)(JP)[!][11MB1, 11MM1]
Sega Rally 2 v1.04 (1999)(Sega)(JP)[!][13M1]
Sega Rally 2 v1.04 (1999)(Sega)(JP)[!][MT B02, MT B04]
Sega Rally 2 v1.04 (1999)(Sega)(JP)[!][MT B02]

SEGA_RALLY2 JPNDisk Master Ripping

HKT-3030 (VA1 maybe), USA NTSC English, ide hdd.

https://mega.nz/file/PJ5HARTC#w3P2OF0MML...Zkr-i2tuoo
It works normally only in low level mode.
Accordingly, without CDDA. Otherwise ingame hangs.
I tried everything loader memory address from the settings.

https://ia801503.us.archive.org/35/items...003%29.zip
Doesn't start at all.

Could you share the pal/ntsc images that work fine for you?

I can't say for sure, but it depends on the configuration, etc.
How about the address 0x8c004800?
And
IDE pin 1 and GND are connected with a 470pf capacitor (voltage is needed for the reset signal).
1pf capacitor on the power cord (for noise suppression and voltage stabilization).
Because the hardware is inevitably old, there are many units with voltage drop, so it is unstable unless you search for it with a tester or oscilloscope. Even with the same settings, it sometimes starts up after 30 seconds (the reset time of Dreamcast).

Sorry for the delay in responding.