ide device not loaded.

[news8019]

I have a problem with mod.IDE to my dream. I think the connections are welded well, because he says that identifies a device. the problem and who do not want to recognize, but do not understand the problem.
Post a picture of the starting dreamshell to better understand the problem.
Thank you for the answer.

[Gillbert]

Are you pretty sure that you soldered every wire in the correct points?

Post some pics of your mod, please.

[news8019]

Thank you for the reply. I enclose a photo, I hope to see well.

[Gillbert]

It seems fine as far I can see.

But I could not see where the end of the wires are connected to. Did you wired them to an IDE connector? Are you using some SATA adapter? More details.

[SWAT]

What IDE devce? Try another and without *smart* adapters.

[news8019]

you, use an SD adapter, I just purchased a hd that arrives in a few days.
It is the version with 44 pins with hd 2.5

[SWAT]

Problem in adapter.

[news8019]

sure? so with a true hd I solve my problem.
I update the discussion, just get me the hard drive

[megavolt85]

SD2IDE don't work with dreamcast

[news8019]

I hope with all my heart is that the problem
Thanks for all the answers

[Gillbert]

Problem with that adapter is because there is no jumper to change to SLAVE mode.

[SWAT]

(21.03.2017 18:05)megavolt85 писал(а):  SD2IDE don't work with dreamcast

Some works, some not.

[news8019]

Arrived now the hard disk, do not boot from HD, and even from sd.

[megavolt85]

you use 80 wire ide cable?

[news8019]

No, of course not. 44 wires

[megavolt85]

gdrom install'ed?

[news8019]

gd-rom is installed, and the console is assembled.

[megavolt85]

i look on photo error when driver set DMA mode
need photo your G1ATA mod

[news8019]

Now I do not have on hand, I can just upgrade to photograph the area G1ATA

[Gillbert]

Did you wired the pin 44 to Ground? If not, do it, pin 44 must be in low state.