88AS8040 IDE2SATA Chip

[dreamcastfix]

(12.09.2016 01:05)megavolt85 писал(а):  DREAM_BIOS_REVOLUTION is bad way. BIOS on Dream IDE Reborn board is good. Need add two test point and remove R532 from main board

The idea is simply to facilitate the installation of DualBIOS. I can not believe the way it is done today can not be improved.



In fact, the board will only be fitted onto the MPR-XXXX harvest, which should have the pin 12 up and connected to the plate, a point with the WE signal is also necessary, simple, in a few minutes modbios / dual bios / region free installed!

I could not understand what it meant to be necessary to remove R532 on the main board?

In fact this board is nothing more than a dip44 adapter TSOP48 with a voltage regulator (for VA0 model plates with 5V voltage) and two resistors 10k fitted with a system that facilitates the connection of the MPR-XXXX, I did not understand why it would be bad idea to facilitate the mod as is done today.

I would also emphasize that the MX chip used is recommended by SWAT in UC's list compatible, could not understand where it would be based on the opnion that this card is a wrong way.

Could you tell us why you think that?